It is small (22.2 x 30.0 x 20.0 cm), lightweight (220 g), waterproof (IP67) and has been designed for prolonged outdoor use in any environment. If the Kunak AIR Pro is going to be installed outdoors, it must use a charger that can withstand these conditions. Input voltage 100-240V AC 50-60 Hz, Output voltage 12V DC, Output current 1.67A. It can be either for European or Global plugs.
The Kunak AIR Pro is always supplied together with a switching adaptor. The photovoltaic panel makes the the ambient air monitoring device totally autonomous from the power grid, allowing the installation anywhere without civil works or in remote locations. The 12-watt and the 6.3-volt high-efficiency monocrystalline solar panel is robust, waterproof (IP67) and has been designed for prolonged outdoor use in any environment. Typical intra-model variability: calculated as the standard deviation of the three sensor means in 1 to 8 months field test between -10 to +30✬ in different countries.Īverage power consumptions of the Kunak AIR Pro in the different modes of operation considering a sampling period of 5 minutes and a sending period of 30 minutes. DQO - Typical U(exp): Data Quality Objetive expressed as the Expanded Uncertainity in the Limit Value obtained between hourly measurements of the device and the reference instruments for 1 to 8 monthsįield test between -10 to +30✬ in different countries, based on the metric from the European Air Quality Directive 2008/50/EC and from the Technical Specification CEN/TS 17660-1:2022.ġ2. Statistical metric: statistics obtained between hourly measurements of the device and the reference instruments for 1 to 8 months field test between -10 to +30 ✬ in different countries.ġ1. Response time: time needed by the sensor to reach 90% of the final stable value.ġ0. Of measurement, based on the metric from the Technical Specification CEN/TS 17660-1:2022.ĩ. Repeatability (measured at laboratory conditions at 20✬ and 50% RH): closeness of the agreement between the results of successive measurements of the same measure carried out under the same conditions It is the minimum concentration that can be detected as significantly different at zero gas concentration, based on the metricįrom the Technical Specification CEN/TS 17660-1:2022.Ĩ. LOD (Limit Of Detection): measured at laboratory conditions at 20✬ and 50% RH. Guarantee range: limit covered by the guarantee.ħ. Operating life: lifetime of the sensor at normal conditions.Ħ. Recommended RH range of the sensor for continuous exposure.ĥ. Operating RH range (Recommended RH range): humidity interval at which the sensor is rated to operate safely and provide measurements. Operating temperature range: temperature interval at which the sensor is rated to operate safely and provide measurements.Ĥ. Resolution: smallest unit of measurement that can be indicated by the sensor.ģ. Measurement range: concentration range measured by the sensor.Ģ. Temperature | Humidity | Atmospheric pressure | Dew pointġ. Temperature | Battery | Charging voltage & current | Signal Multi-Band 2G/3G/4G | Ethernet | Modbus RTU SlaveĬO, CO 2, NO, NO 2, O 3, SO 2, H 2S, NH 3 & VOCs
30 ppm in logger pro picture crack#
Logger Pro Crack sports powerful analysis tools, including curve and linear fits, derivatives, tangent lines, integrals, as well as statistics related utilities, such as histograms or frequency graphs.
0 kommentar(er)
